Legrand WKD ProSeries Underfloor Duct Brass Trim Flanges Manuel d'utilisateur télécharger pdf

Floor Box and

Walkerduct Pro Series

System

Brass Trim Flanges

Cat. Nos. 817B, 827B, and 837B

INSTALLATION INSTRUCTIONS

Floor Boxes with Slotted Retaining Flanges:

1. Slide head of inverted adjusting screw* into retaining

flanges for trim attachment.

2. Place trim ring over the four adjusting screws and

tighten until snug using a narrow blade screwdriver.

Tighten individual screws in small increments to

prevent binding.

3. For tile floors, cut the floor covering around the trim

ring or tile up to the ring for a flush appearance. Trim

ring may be laid over tile for a flanged look (same as

with carpet).

4. For wood floors requiring a flush look, cut an opening

(1/8" [3.2mm] deep) conforming to the ring perimeter

and recess trim ring into opening.

*NOTES:

1. Some floor coverings such as thick carpet may require the use

of the longer adjusting screws.

2. Hardware bag No. 97650A not needed for this installation.

Floor Boxes with Threaded Retaining Flanges:

1. Secure trim ring to retaining flanges using four flathead

screws* provided.

2. For tile floors, cut the floor covering around the trim ring

or tile up to the trim ring for a flush appearance. Trim ring

may be laid over tile for a flanged look (same as

with carpet).

3. For wood floors requiring a flush look, cut an opening

(1/8" [3.2mm] deep) conforming to the ring perimeter

and recess trim ring into opening.

*NOTE: Hardware bag No. 97650A needed for this installation.

Illustration Shown With 880S1 Omnibox

and 817B

Trim Flange Utilizing a Carpet Application.

Illustration Shown With 827B Trim Flange Utilizing a

Flush Tile Floor.

Walker

electrical systems conform to and

should be properly grounded in compliance with

requirements of the current National Electrical

Code or codes administered by local authorities.

All electrical products may present a possible

shock or fire hazard if improperly installed or

used. Walker electrical products may bear the

mark as UL Listed and/or Classified and should

be installed in conformance with current local

and/or the National Electrical Code.

1 2

Résumé du contenu

Page 1 - Brass Trim Flanges

Floor Box and ®Walkerduct Pro Series System Brass Trim FlangesCat. Nos. 817B, 827B, and 837BINSTALLATION INSTRUCTIONSFloor Boxes with Slotted Retainin

Page 2 - Figure 3

®Walkerduct Pro Series Presets:1. Use a Walker insert finder (Cat. No. 480) or other electronic locator to find center of preset. Cut and remove carpe

Commentaires sur ces manuels

Pas de commentaire

Legrand WKD ProSeries Underfloor Duct Brass Trim Flanges Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Legrand WKD ProSeries Underfloor Duct Brass Trim Flanges. Legrand WKD ProSeries Underfloor Duct Brass Trim Flanges User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Legrand WKD ProSeries Underfloor Duct Brass Trim Flanges