Legrand C118RAC Manuel d'utilisateur télécharger pdf

Auto/Clamp

Eliminates separate cable clamps as well as the tools

usually needed for installation. To install the cable, insert

stripped or non-stripped nonmetallic wire into the

Auto/Clamp

opening and pull through to the desired length.

The cable is automatically secured and the installation is

complete. There are no other operations for the electrician

to perform. Contractors can look forward to saving time

and money with every Auto/Clamp

plastic box installation.

(One cable per Auto Clamp)

Quick/Entry

Speeds installation by eliminating needs for tools.

Another time-saving idea is Quick/Entry

, a method that

allows you to push stripped or unstripped nonmetallic cable

into a single plastic box without removing knock-outs.

Jagged edges usually formed in other boxes are

eliminated.

(Multiple cables per Quick-Entry)

Quick/Click

Fast, easy and secure installations. The unique, labor

saving Quick/Click

design secures the wiring device quickly

and easily. Simply push in the mounting screws with a

screwdriver and turn the screw one or two turns.

With Quick/Click

mounting, you cannot cross-thread or

strip a device mounting screw.

Stabilizer

In a 2 x 4 application, the stablizer leg rests against the interi-

or surface of the opposing wall virtually eliminating inward

movement of the box.

Metal

Remove the rear stabilizing bar from its shipping position and

insert the long end into the slot located underneath the dry-

wall stop. For applications with wood studs, break off small

section of stabilizing bar where marked before insertion.

Integral

P122B is optimally sized for Steel studs only. All others may

be used with both steel and wood with little or no deflection.

PLASTIC BOXES

INSTALLATION INSTRUCTIONS

Auto/Clamp

clamping action

Just push cable

in and pull to

proper length.

Proper mounting

position of

stabilizing bar.

1 2 3 4

Résumé du contenu

Page 1 - PLASTIC BOXES

Auto/Clamp®Eliminates separate cable clamps as well as the toolsusually needed for installation. To install the cable, insertstripped or non-stripped

Page 2 - Box Extender

Wood and Steel StudMetal Bracket1. A CT-1 Crimping Tool, is recommended for the installationof these boxes to steel studs.Place box flush against side

Page 3 - Low-Voltage Boxes and Divider

Ceiling Box1. Nail-On or J-Bracket types, just nail the ceiling boxaccurately to the stud.Note: The stud should rest on the built-in step (seediagram)

Page 4 - Old Work

P.O. Box 4822, Syracuse, NY 13221-4822 • www.passandseymour.com • (800-223-4185) Printed in USAOld WorkCeiling Boxes1. Cut a 3-3/4" round hole in