Legrand CSD1000 Manuel d'utilisateur télécharger pdf (Page 4)

CAUTION

TURN POWER OFF AT THE CIRCUIT BREAKER BEFORE

INSTALLING POWER PACKS OR SENSORS.

www.passandseymour.com

WIRING DIAGRAMS

1 PACK/ 1 SENSOR

HOT

Neutral

Black

White

Power

Pack

White (Neutral)

RED (LOAD)

Switch

Lighting

Load

BLUE

BLACK

RED

BLUE

BLACK

RED

Control (24VDC) Out

Common

+24V In

Wires

Red (Line)

WIRING DIRECTIONS

Each Pass & Seymour PWP series power pack can supply power for up to 3 CSD1000

sensors. When using more sensors than this, multiple power packs are required.

Refer to the wiring diagram(s) below for the following procedures:

Connect the low voltage:

• RED wire (+24VDC) from power pack to the +24V terminal on the sensor.

• BLACK wire (Return) from power pack to Common terminal on the sensor.

Wiring a SINGLE LIGHTING LOAD CONTROLLED BY OCCUPANCY – connect:

• BLUE wire from power pack to Control Out terminal on sensor.

1 2 3 4 5 6 7 8 9 ... 12 13

Pas de commentaire

Legrand CSD1000 Manuel d'utilisateur Page 4