Legrand RC9AM2TC Manuel d'utilisateur télécharger pdf

IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING.

Products Covered: RC9AM114TC, RC9114TCLJB

CAUTION: DO NOT operate tile stripper or resurfacing equipment over top of covers. This may result in damage to the surface finish of

the product.

Suitable for use in air handling spaces in accordance with Sec. 300-22 (C) of the National Electric Code.

Step 1. Layout and locate position of hole(s). Step 2. Remove 6 1/2" [165mm] section from carpet

or tile. Use template provided.

CAUTION: Holes shall be spaced a minimum of 2' [610mm]

on center and not more than one hole per each

65 sq. ft. [6 sq. m] of floor area in each span.

NOTE: Be certain to drill hole at least 4" [102mm] from any wall NOTE: For tile thickness greater than 3/4" [19.1mm] consult factory.

or pillar to leave enough room for poke-thru cover assembly.

Step 3. Core drill hole. Step 4. Insert assembly into hole.

CAUTION: Poke-Thru cannot be rotated in hole after insertion into floor.

RC9AM114TC & RC9114TCLJB

Poke-Thru Series

INSTALLATION INSTRUCTIONS

Installation Instruction No.: 1 002 364 R1 – Updated November 2002

Walker

electrical systems conform to and should be properly grounded

in compliance with requirements of the current National Electrical Code

or codes administered by local authorities.

All electrical products may present a possible shock or fire hazard if

improperly installed or used. Walker electrical products may bear the

mark as UL Listed and/or Classified and should be installed in

conformance with current local and/or the National Electrical Code.

24" [610mm] Min

Center – Center

6 1/2"

[165mm] Diameter

3" [76mm] Diameter Core Drill

3 1/16" [78mm] Actual Diameter

Push Down

CAUTION: Be certain to drill hole at least 4" [102mm] from any wall or

pillar to leave enough room for poke-thru cover assembly.

CAUTION: For tile thickness greater than 3/4" [19.1mm] consult factory.

CAUTION: Poke-Thru cannot be rotated in hole after insertion

into the floor.

1 2 3 4

Résumé du contenu

Page 1 - Poke-Thru Series

IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING.Products Covered: RC9AM114TC, RC9114TCLJB CAUTION: DO NOT operate tile stripper or resurfac

Page 2

Step 5. Remove screw plug and replace with Step 6. Attach conduit, pull wires and the a 1 1/4 trade size conduit connector. installation is complet

Page 3

The RC9AM114TC and RC9114TC Series Poke-Thru Devices are UL Listed and Classified to U.S. and Canadian safety standards to the following conditions:Th

Page 4 - Carpet/Tile Cutout Template

The Wiremold Company U.S. and International: 60 Woodlawn Street • West Hartford, CT 061101-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-2

Commentaires sur ces manuels

Pas de commentaire

Legrand RC9AM2TC Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Legrand RC9AM2TC. Legrand RC9AM2TC User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Legrand RC9AM2TC