Legrand 6B21E Manuel d'utilisateur télécharger pdf

Wiremold / Legrand electrical systems conform to and should be

installed and properly grounded in compliance with the

requirements of the current National Electrical Code, Canadian

Electrical Code or codes administered by local authorities.

All electrical products may represent possible shock or fire hazard

if improperly installed or used. Wiremold / Legrand electrical

products are UL Listed, and should be installed in conformance

with current local and/or the National Electrical Code.

Power Commander

POWER DISTRIBUTION UNITS

INSTALLATION INSTRUCTIONS

Installation Instruction No.: BK007R1 – Updated March 2007

The Wiremold Power Commander

Power Distribution Units are UL/cUL Listed/ Recognized by Underwriters Laboratories, Inc

under File E173292. All products are in compliance with the national Electrical Code and the Canadian Electrical Code.

The 3A, 3B, and 4B Series are UL/cUL Listed and comply with the Standard for Information technology Equipment – Safety – Part 1.

UL60950-1. They are available in a 1 5/8" W x 2 7/8" H [41mm W x 73mm H] housing with variable length.

The 3A and 3B models are rated 120Vac, 24A. Each circuit may carry up to 12A as long as the total current does not exceed 24A.

The 4B Series is rated 208Vac, 32A. Each circuit may carry up to 16A as long as the total current does not exceed 32A.

The JPDU-A is UL/cUL Recognized and complies with the Standard for Information Technology Equipment, UL1950.

The JPDU-A is rated 120Vac, 24A. Each circuit may carry up to 12A as long as the total current does not exceed 24A.

The D-Series Custom Power Distribution Units are UL/cUL Listed and comply with the Standard for Information Technology

Equipment – Safety – Part 1, UL60950-1. They are available in a 2" W x 1 3/4" H [51mm W x 44mm H] housing with variable length.

The D-Series is rated 120Vac, 12 A or 16A depending on the configuration ordered.

CAUTION: The socket outlet that

powers the PDUs should

be installed nearby and

be easily accessible.

STANDARD HARDWARE INSTALLATION

Attach the Spring Clips to the cabinet frame or cabinet wall making sure the top clip is no more than 1

inch [25mm] from the top of the unit. Insert the 1/4 - 20 Phillips screw through the spring clip as shown,

and then through the cabinet frame or cabinet wall. On the other side of the mounting surface, put the

1/4 lock washer over the exposed Phillips screw and tighten into place with the 1/4 - 20 nut. Once the

spring clips are secure, place unit in one side of the clips and snap the other side into position.

1/4-20

Phillips

Spring

Clip

1/4 Lock

Washer

1/4-20

Nut

1 2 3 4

Résumé du contenu

Page 1 - Power Commander

Wiremold / Legrand electrical systems conform to and should beinstalled and properly grounded in compliance with therequirements of the current Nation

Page 2

JPDU-A FRONT MOUNT (1U) INSTALLATION MOUNTING INSTRUCTIONS: JPDU-A SIDE RAIL (0U) INSTALLATION MOUNTING INSTRUCTIONS: With a 5/16" nut driver, un

Page 3

RECOMMENDED MOUNTING INSTRUCTIONS - Remote Display:All “-RAM” models contain a remote display unit which can be mounted in a 1U rack mount face plate.

Page 4 - MOUNTING ACCESSORIES

Wiremold / LegrandU.S. and International: 60 Woodlawn Street • West Hartford, CT 061101-800-621-0049 • FAX 860-232-2062 • Outside U.S. 860-233-6